*  Full system evaluation.

*  Lubrication of applicable motors.

*  Replacement of 1″ Air Filter.

*  Charge Air Conditioner with Up to 1LB of R22 or R410A Freon.

*  Confirm Thermostat accuracy, calibrate if necessary.

*  Check evaporative coil for water leaks or visual signs of mold.

*  Seal off air leaks on evaporative coil, plenum and base.

*  Inspect blower motor and wheel for vibration and debris.

*  Check return vents for obstructions.

*  Record supply and return temperature before and after.

*  Check the drain line for proper draining, blow out the line if necessary.

*  Inspect and tighten all electrical connection at A/C and Fuse box.

*  Visual inspection of all accessible heat exchanger.

*  Test for Carbon Monoxide around the furnace and at the vents.

*  Seal off air leaks around evaporative coil, plenum and base.

*  Confirm Thermostat accuracy, calibrate if necessary.

*  Inspect blower motor and wheel for vibration and debris.

*  Clean up (send down) flame sensor.

*  Test flue exhaust for proper draft.

*  Check for flame roll out.

*  Check gas supply line if meets earthquake requirements.

*  Remove and clean burners and heat exchanger compartments.

*  Test all accessible connections for gas leak.

*  Inspect integrity of return platform, insure it meets safety standards.

*  Check for proper angle (90*) of Furnace and Evap Coil assembly.